black and decker home protector sensor 9103

#BLACK AND DECKER HOME PROTECTOR SENSOR 9103 MANUAL#

Repeat this cycle coming from the other direction and again mark the spot where the upper red LED lights and beeper sounds. The upper red LED will light and a beeper will sound when an edge is detected, mark that spot (Figure 4).Slide sensor slowly, (Figure 3,) horizontally across surface of wall without lifting or tilting.The unit will beep once while it is calibrating,.Press in and hold the stud sensor ON/OFF button (C).Hold unit straight up and down and place flat against wall as shown in Figure 2.Insert two fresh AA batteries making sure to match (+) and (-) terminals correctly. Remove the battery compartment cover (D) by pressing down in the center of the cover and pulling back. Always turn off the power when working near electrical wires. Because studs are normally spaced 16 inches or 24 inches apart and are 1-1/2 inches wide, beware of anything closer together or of a different width. These items may be detected by the Stud Finder in the same manner in which studs are detected. Use caution when drilling, nailing or cutting into walls, floors and ceilings which may contain electrical wiring or pipes.

Use of any other batteries may create a risk of fire. Use the stud sensor only with the specifically designated batteries.Do not operate the stud sensor in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust.SAVE THESE INSTRUCTIONS Safety Instructions To reduce the risk of injury, user must read and understand instruction manual.

#BLACK AND DECKER HOME PROTECTOR SENSOR 9103 MANUAL#

Black and Decker SF100 Stud Sensor Manualįor any technical support, or customer service on this product please call our tech support or customer service team at 877.312.4547 (EST) or send us an email at THIS MANUAL FOR FUTURE REFERENCE.

Black and decker home protector sensor 9103